- The latest stable version of the A320 mod v0.10.1 has now been released!
https://github.com/flybywiresim/a32nx
Added
- [ADIRS] Added ADIRS knob functionality
- [ADIRS] Added ADIRS ALIGN light functionality
- [ADIRS] IRS alignment affects PFD and MFD displays and indicators
- [ADIRS] IRS alignment affects TAT and SAT indicators on lower ECAM
- [ADIRS] IRS alignment time dependent on latitude
- [ADIRS] IRS alignment time remaining displays on upper ECAM
- [BRAKES] Brake gauge now properly reflects status of toe brakes and parking brakes
- [CHRONO] Added basic chronometer functionality
- [ECAM] Added full APU Bleed functionality to APU ECAM page
- [ECAM] Added F/CTL ECAM page with support for elevator, aileron, and pitch trim movements
- [ECAM] F/CTL ECAM reflects current ELAC and SEC status
- [ECAM] Lower ECAM automatically switches to DOOR page when a door is opened
- [ECAM] Lower ECAM automatically switches to APU page when APU master is switched on
- [ECAM] Added ECAM memos 'OVERSPEED', 'GND SPLRS ARMED', 'SEAT BELTS', and 'NO SMOKING'
- [MFD] Added range change indicator to navigation display
- [MFD] Added GPS status to navigation display
- [MISC] PFD, MFD, and ECAM displays now present a self-test upon powering up
- [MISC] PFD, MFD, ECAM, and MCDU displays no longer work only on battery - require external power or APU/engine generators
- [MISC] Added seatbelt sign switch functionality
- [MISC] Added no smoking sign switch functionality (full range of motion currently restricted)
- [MISC] Added moveable dummy knobs for cockpit, fwd, and aft cabin air conditioning controls
- [MISC] Added full (non-interactive) checklist
- [SOUND] Added chimes for seatbelt and no smoking switches
Changed
- [APU] APU start and flap logic adjusted
- [APU] APU EGT is now adjusted for ambient temperature
- [APU] Smoothened APU EGT curve
- [APU] APU bleed now momentarily drops when bleed valve is opened
- [BRAKES] Fixed accumulator pressure changing when on battery
- [BRAKES] Autobrake is now off when starting cold-and-dark
- [ECAM] APU gen arrow now only shows when APU connected to bus
- [ECAM] APU 'FLAP OPEN' no longer displays instantly but reflects actual flap opening time
- [ECAM] Bleed ECAM page implemented
- [ECAM] Initializes on DOOR page instead of FUEL
- [ELEC] Battery display is now always on and displays battery voltage instead of main bus voltage
- [FCU] Altitude selection knob no longer requires explicit push/pull interaction to update new altitude target
- [FCU] Increased size of managed mode indicators
- [FCU] Adjusted alignment of altitude and vertical speed displays
- [FMA] Corrected '1FD2' to '1 FD 2' on FMA
- [FMA] Fixed 'SPEED' appearing whilst on the ground and A/THR requiring AP
- [FMA] Fixed various issues with thrust modes appearing incorrectly
- [FMA] Fixed thrust modes appearing when in GS or VS modes
- [FMA] Fixed 'SRS' appearing as armed, fixed 'SRS' disengagement conditions
- [FMA] 'SPEED' no longer appears with autopilot/auto-throttle disengaged
- [FMA] 'NAV', 'CLB', and 'DES' no longer appear with flight directors disabled
- [FMA] Fixed 'SPEED' and 'MACH' flickering at cruise
- [FMA] Improved 'OP DES' and 'OP CLB' trigger logic
- [FMA] Fixed 'CLB' and 'DES' appearing at incorrect times as well as on ground
- [FMA] Fixed 'NAV' not appearing with AP disengaged
- [FMA] Fixed 'ALT' in blue not appearing when changing altitudes
- [FMA] Fixed 'ROLLOUT' appearing after leaving the runway
- [FMA] Fixed 'GS' appearing with no FD's active
- [FMA] Fixed 'A/THR' appearing enabled on the ground
- [FMA] Fixed 'MACH' appearing on the ground
- [FMA] Fixed 'SPEED' and 'MACH' not appearing in some situations
- [FMA] Fixed 'THR LVR' and 'THR IDLE' not appearing in some situations
- [FMA] Decreased sensitivity for 'THR CLB' appearing on the FMA.
- [FMA] Fixed 'THR IDLE' not appearing when descending
- [FMA] Fixed 'THR LVR' appearing when in cruise phase
- [FMA] Fixed 'SPEED' not appearing with AP off but A/THR on
- [FMA] Fixed AP and FD FMA modes appearing green instead of white.
- [FMA] Fixed 'FINAL APP', 'LAND', 'FLARE', 'ROLLOUT' appearing with FD off
- [FMA] Fixed a situation where 'SPEED' wouldn't appear
- [FMA] Fixed 'HDG' appearing when on the ground
- [FMA] Fixed 'SINGLE' and 'DUAL' not appearing on ILS approaches
- [FMA] Fixed 'CAT' not appearing on FMA, improved logic to match ICAO criteria
- [FMA] Corrected logic for engaging ILS categories
- [FMA] Improved A/THR FMA modes logic.
- [FMA] Improved logic for 'CAT' modes on ILS approaches
- [FMA] Added support for 'ALT G/S' armed FMA mode
- [FMA] Improved CAT logic on FMA
- [LIGHTS] Brightness knobs for PFD, MFD, ECAM, FCU, and overhead panel are turned down when spawning cold-and-dark
- [LIGHTS] Reduced ambient cockpit lighting
- [LIGHTS] Change minimum brightness to 0 on all displays
- [MISC] Improve phase change logic
- [MISC] Change initial FLT states
- [MISC] Fixed engine selector on crank when starting in-flight or on approach
- [MFD] Adjusted look of wind arrow on navigation display
- [PERF] Overpowered engine thrust reduced
- [PERF] Fuel consumption improved
- [TEXTURES] Adjusted textures for panels, pedestal, and cockpit decals
- [TEXTURES] Adjusted colors on overhead panel
Removed
- [LIGHTS] Taxi light no longer bleeds into cockpit
- [SOUND] Removed 70ft and 60ft radio altimeter callouts
- [SOUND] Removed overspeed voice warning (master warning chime will still play)